iWire Fuel Pump Controller Hardwire Kit for Radium Hangers - Double Pump

You've just installed your brand new Radium hanger with its two glorious pumps. Now you're ready for "all the fuel in the world," but at that moment, you realize that the connectors don't match up. In fact, this hanger doesn't even have a connector at all. STOP! DON'T CUT ANYTHING! Our iWire Plug and Play Hardwire kit has you covered to adapt the stock connector to the ring terminals found on the Radium hanger for fuel level and temp. In addition, we also have you covered to quickly setup up for the primary and secondary pumps as well!

Two Pumps are Better Than One, But Two Pumps ARE a Lot of Fuel

A staged fuel system (primary and secondary pumps) is a critical component to making power and having a very streetable car. If the two pumps are running at full blast, the fuel system will be over-pressurized, which makes it difficult for tuners to get your car to run smoothly. We create the ideal staged setup by retaining the primary pump functionality from the factory with the all-important low, medium, and high settings. These settings help maintain consistent fuel pressure when idling and cruising. When the boost kicks in, the secondary pump activates with the manifold pressure switch (Pressure Switch Add-On in the drop downs) so that you never run out of fuel.

Not all Hardwire Kits are Created Equal

We have thought of every component needed to make sure your installation is a simple as it can be and handle anything you throw at it. While other kits are cheaper, they are just a fuse and relay. These DIY kits leave you all the pain to figure out how to run the harness, connect the wires, and get the pumps to work right. Even if you managed to figure it all out, you're still left with the nagging concern of a weak connection causing the pump to cut out at the very worst possible moment.